Professional product for hair removal – ITALWAX Line Classique
A special wax formula has been specially developed for male hair removal. Increased adhesion of the wax to coarse hair allows 100% removal of thick male hair the first time. Waxing does not damage the skin. Painful sensations are reduced to a minimum. It is used to remove hair from the shoulders, chest, back, underarms and intimate area.
Melting temperature: +40 to +45°C
Application area: face, underarms, bikini area
Application method: spatula
Removal method: no strip
Features
How to use
- Heat the wax in an electric wax heater to a temperature of +42°C.
- Treat the area to be waxed with a lotion containing alcohol.
- Apply a small amount of talcum powder.
- Apply a thin layer of wax with a spatula, regardless of the direction of hair growth, but pulling towards you, leaving a small "petal" to grab later (try to treat the armpits with a single application).
- WARNING! Apply the wax without haste, press firmly on the spatula applying the necessary pressure.
- The wax will harden in 5 to 6 seconds (wax ready for removal should not stick to the hand to the touch).
- Pre-tensioning the skin in the opposite direction to the tear, quickly remove the wax by pulling it towards you, parallel to the skin. Repeat the procedure on the next area.
- After waxing, treat the skin with a soothing, cooling, oil-free product, such as a cooling cream/gel or "White Orchid" lotion emulsion.
Precautions
The wax stretches like caramel and is difficult to remove.
Cause: the wax hasn't had time to harden.
Solution: powder the wax with talcum powder, wait 2-3 seconds, then remove it.
After removing the wax, hairs remain.
Cause: the spatula with the wax was not pressed against the skin enough, so the hairs were not caught in the wax layer.
Solution: apply wax to the area of skin with the remaining hair by pressing the spatula firmly against the waxing area.
After removing the wax, wax remains on the skin at the edges of the application.
Cause: uneven wax application.
Solution: form an application with an even layer in the middle and at the edges.