Protocol Categories
Protocole de microneedling avec exosomes – Revive NX
Microneedling protocol using Revive NX Exosomes professional serum, designed to improve the appearance of the skin and optimise the penetration of active ingredients. This treatment includes skin preparation, microneedling and the application of appropriate skin care products to soothe and moisturise the skin after the procedure.
START PACK Microneedling Revive NX - 5 Treatments
Cleanse the skin with KART Pomegranate Soap to remove impurities and prepare the skin for the procedure. Another suitable product may be used depending on the professional's preference. Ensure the integrity of the skin before proceeding.
Pomegranate Soap KART 7105
Prepare the Revive NX Exosomes solution by mixing the activator solution with the lyophilised nidosomes according to the product protocol. Mix gently until a homogeneous solution is obtained.
Exosome Complex Revive NX - Cellular Regenerating Serum
Open a sterile single-use cartridge. Choose the right cartridge for the area and technique being used. Fill the cartridge with the prepared solution. Adjust the product flow rate on the cartridge (recommended level: No. 1). Install the cartridge on the Nidosome Injector and check that the device is working properly before the procedure.
24 needle cartridges - For Nidosome Injector
Professional Microneedling Pen 0.5 mm - injector Revive NX
NANO cartridge - For Nidosome Injector
Cartridge of 12 needles - For Nidosome Injector
Cartridge of 36 needles - For Nidosome Injector
Perform microneedling by applying the Revive NX Exosomes solution evenly over the treated area using the Nidosome Injector. Work in zones with regular strokes, maintaining even distribution of the product throughout the procedure. Adapt the technique and intensity according to the area and skin sensitivity. Refill the cartridge if necessary during the procedure. Use the prepared solution within a maximum of 12 hours.
Apply Celltermi Revive Post-Procedure Regenerating Mask to clean skin after microneedling. Leave on for 15 to 20 minutes, then gently remove. Gently massage the excess serum into the skin.
Mask Regenerating Post-Procedure Celltermi Revive
Apply Revive NX Nidosome Complex to complete the treatment after the procedure. Follow with Celltermi Peptosome Repair Cream, then apply Celltermi Peptosome Repair Mist to complete the protocol.
Celltermi Peptosome Repair Mist – Cellular Regenerating Mist
Celltermi Peptosome Repair Cream – Cellular Regenerating Cream
Green Nitrile Gloves (Size S) – Powder-Free
Black nitrile gloves (size M) – powder-free
Pink nitrile gloves (size S) – powder-free
Pink surgical mask - Akzenta
Pink nitrile gloves (size M) - powder-free
